Discussion Locked

Win98 Installation

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I tried installing win98 over a an already existing version that I had trouble with and couldn't solve. The installation went fine until windows requested to restart the computer. The computer restarted normally, then I got the message "You are in MS Dos mode do you want to switch to windows mode? Y/N". If I answer yes then the computer goes into loop and if I answer no it goes into Dos mode and wouldn't start windows. what could be the problem? And I don't want to format the HDD and make a clean installation.

14 replies

by dmiles

Using the CD only,insert in drive and see if you can install from cd,you have corrupt system files and win.com,run through set up without the startup disk which could be holding corrupt files,if this does not work you will have to do a clean install

by baziite

Was this startup message initially your problem ie. "You are in MS Dos mode do you want to switch to windows mode? Y/N" ?.

Try the following . At startup , before windows boots , hold down the F8 key to go to the startup menu . Select Safe Mode then boot the computer , hopefully it will boot OK . Then Go to Accessories / system tools / sytem information then on the tools menu select system configuration utility . Open the Autoexec tab and UNcheck everything in it . APPLY /OK then restart the computer .

Good Luck !!!!!!

by m.a.s. matrix

you can not install win 98 over win 98. it duplicates certain keys in the registry and makes a mess as you can see. unless you know how do properly edit the reg, you will have to dump the hard drive and reinstall a new copy of win 98

by bob sellman

If you're having trouble with the existing installation that you can't solve, then trying to reinstall over the defective version is not likely to give you a good installation. In fact, since you are running into more problems, it appears the problems with the existing version are not solved by installing over it.

I'm afraid that you will have to bite the bullet and format the HDD and make a clean installation if you want to take the least amount of time and end up with a more reliable installation.

Good luck.

by flan

You can always specify a different location for the install location. Instead of c:\windows choose c:\win

by shmaltz

try to make a clean installation without formatting to do that:
first make sure that all win98 setup files are coppied to the HDD, then restart the computer in MSDOS mode using a startup disk, at the command prompt type
"c:"
"attrib io.sys -h -r-s"
"del io.sys"
"attrib msdos.sys -h -r -s"
"del msdos.sys"
"del *.*" (make sure you dont have files in the root dir that you might need if you do copy them to a subdir since the above command does net delete files only in the dir you are in)
"cd windows"
"cd system"
"del *.*"
"cd.."
"cd system32"
"del *.*"
"cd.."
"del *.*"
"cd.."
"ren windows oldwin"
"ren prgram~1 oldprg"
"ren mydocu~1 olddoc"
then run setup.exe from the HDD when you are finished installing if you had data inProgram Files you can recover it from the dir called oldprg (only data not programs you will have to reinstall all programrs)then you can delete the dir called oldwin (if you try to delete it before you reinstall windows for some reason the deltree DOSCOMMAND dosnt work on it).

by shmaltz

The command that reads :
"ren prgram~1 oldprg" is a mistake it should read:
"ren progra~1 oldprg"

This discussion is closed to new replies.