Discussion Locked

Win98 SE "Windows Proctection Error"

0 helpful
20 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I already FDISK and formatted the drive. When it's getting ready to run for the first time I get a "Windows Protection Error. You need to restart computer". I will restart it and it will still give me same error. I've change HDs, and memory. What should I do to install Win98 properly?

20 replies

by Member 21361443

The first thing I would check would be the video card. It may be bad. Try swapping it for another one.

If that doesn't help, I would remove all the adapter cards in the computer except the video card (and hard drive controller, if necessary). This would include modems, sound cards, everything not absolutely critical to get the machine running.

Try the install on the stripped down machine, and see if that helps!

Hope this helps!
Brian Lusk
brianlusk@netzero.net

by dft3

To elaborate a little further on the previous answer, after you do this, you want to slowly introduce new parts into the system until you find out which one is causing the problem.

However, Windows Protection Errors are usually either due to the motherboard or the RAM itself. For that reason, you may consider not going as far as he previous response suggested. The easiest thing to try first would be swapping out one of the RAM chips until you find the one that is bad.

If that doesn't help, then as previously suggested, strip the machine done to its bare essentials to run and slowly introduce new parts until you find the bad one.

If at this point you're unable to find something bad, then the problem is more than likely the motherboard.

Good Luck!

by grbeckmeyer

Go the the MS knowledge base and find article Q136337. This will step you through various boot procedures that will narrow down the problem. I have used this many times successfully and know many others who have benefitted from this. My experience has generally been a problem with a NIC driver.

by saihib

Try Microsoft Knowledge Base article Q149962 - Troubleshooting Windows Protection Errors.

by clover252525

Disable "sounds" in the CMOS peripherals prior to running Win98 setup. Let Win98 detect and install every other device except your sound card. If everything is working fine, reboot, enter CMOS and enable sounds. Now it can detect your sound card andassign it non-conflicting IRQ and DMA.

clover

by dmiles

Go over your connectors and make sure that all connectors are set in place and you donot have one that is loose,in the process you may have pulled one loose and it will cause this same problem.

by wbutler188

JUST TO ADD TO ALL THE OTHER WELL WISHERS,
I THINK IT MAY BE THE MEMORY CHIPS AS OME OF THE OTHERS SAID.
IF NOT TRY THESE:
IN BIOS MAKE SURE THERE IS NO VIRUS PROTECTION IN THE BIOS ITSELF, DISABLE IT IF PRESENT.
CHANGE ALL IDE CABLES.
CHANGE CD ROM DRIVE FOR ANTOHER. I HAD THAT HAPPEN TO ME. AN MAKE SURE THAT THE CD ISNT SCRATCHED.

by fariase

Make sure you processor is not overclocked, and that the voltage settings are correct for the processor you are using.

by jmkirwin

I often get this message after my son installs game software. The game software usually creates an Autoexec and config files. If I delete them, or F8 and skip them it usually gets up and running. I have also got into safe mode and scanned and defraged and it solved the problem.

This discussion is closed to new replies.