Discussion Locked

Windows 2000 Server Clock Slowdown

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have installed W2K on my HP LC 3 Netserver 3 times now and all with the same end result. The Windows clock slows down. When I reboot, the system clock is correct, then I start "using and losing". I begin to run applications and "time stands still". The Windows clock starts losing time. I tried changing the display refresh from 60 to 75 and I thought it made a difference but it did not. I have stopped the Windows Time service as well as most all other services.

The mouse starts to drag and the windows open very slowly. All the programs seem to work. Windows and TCP/IP Networking are functional, it is just that this system and its clock progressively grow slower as time trudges by.

11 replies

by hippo

Looks like the system is generally running very slowly. I don't know the spec of the machine but check out MS minimum requirements for W2K. If its ok, run task manager and see if a process is eating resources.
Hope this gives you a starting point.~Tony

by tomtowle

I should have mentioned that it has 500 Mb of RAM, runs dual CPUs at 500 Mhz and has 16 Gb of RAID-5 disk space. Have run Task Manager but nothing is apparent. Mouse still drags slow and jerky. Time stands still when interactive processes take place. If Task Manager is the process, its window and related process will have the same effect.

by jcoltrin

I would check to see if your anti-virus software is the culprit (if you're using, you didn't mention). I have found that F-Prot caused several strange problems including but not limited to an inability to save .xls files to a network drive. I would also try uninstalling other applications one at a time to see if an application is the culprit. If no applications had been installed, check your system CMOS for any paramaters that need to be changed. As a last resort, check your motherboard vendor for any BIOS/Firmware updates. Good luck

by tomtowle

Brand new install...NO antivirus...HP Netserver Navigator CD comes bundled with the server and has the latest BIOS and update program. It has already been run. Thanks for your suggestions. Noone seems to want to address the Windows clock issue.

by curt.knight

Sorry, this isn't an answer. Instead, a plea for follow up if you get a definitive answer to this problem. I've had the same thing going on with a Win98SE system (and WIN95 on the same hardware before that).

It's like it's the problem that doesn't really exist...

by sarsone

Way too funny....I thought i was the only one

I have the same issue with Win 98se where the clock, slowdown and hesitation exist and get worse over time.

Still have no clue and i have done everything except replace the CPU and Motherboard.

this one is a challenge!

by sarsone

OK, after swapping everything out including processor, i still had the same problem under 95 and 98.

Replaced the Motherboard.....problem went away.

Put motherboard in another PC...same problem

Conclusion.....motherboard

This discussion is closed to new replies.