12 replies
by Jctech2025 Accepted solution
by oh smeg Accepted solution
If it has a plug in Video Card is it seated properly.
AGP and some PCI XPress Cards wiggle in their sockets on some M'Boards and become disconnected slightly. The fix here is to Remove and re-seat the Video Card.
That of course is if I'm reading your question right and there is no display at all.
However if there is a POST Screen and then nothing how did you setup the Dual Boot?
Did you install both the 7 and 08 on the same partition?
If you did this one will overwrite the other and not work. Normally you install different versions of Windows to different Partitions and then when the system first starts you chose which to start with from the prompt.
Did you use some form of Vitalization Product like M$ Vitalization?
Anyway regardless if there is a POST Screen you are going to have to tell us [b]"Exactly"[/b] what you have done here so we can offer some suggestions. ;)
Col
by Jctech2025 Accepted solution
by oh smeg Accepted solution
Try the Ultimate Boot CD available free here
http://download.cnet.com/Ultimate-Boot-CD/3000-2130_4-51584.html?tag=mncol;7
Burn the ISO to a CD and then boot off the CD you will be greeted by a Menu that allows you to test the hardware and so on or Boot Off the HDD. Go to the Boot off HDD Option and see if you can manually select anything.
it's just possible that the Boot Loader has been messed up or maybe something worse. At the very least you should be able to examine the contents of the HDD/s and make sure that the Partitions still exist and have data ion them. ;)
Col
by Jctech2025 Accepted solution
by Jctech2025 Accepted solution
by oh smeg Accepted solution
Sounds as if the PS has started going to [b]Silicon Heaven.[/b]
If you are lucky. If not it could be something much worse.
Remember just because Fan's Run or LED's Flash on doesn't mean that the PS is actually working correctly. The Fan's and LED's only indicate that the 12 V DC Rail have sufficient power to run the fans and so on. It in no way implies that the 5 V DC or 1.3 V DC Rails have any Power or sufficient Current to run the computer.
Col
by Jctech2025 Accepted solution
by Jctech2025 Accepted solution
by oh smeg Accepted solution
That's called the Supplementary 12 V Lead.
Most times it's a 4 pin connector but depending on the M'Board it can be a 4, 6 or 8 Pin connector and must be connected so that the system works. ;)
Col
by Jctech2025 Accepted solution
Second power rail!
So I got it got it working. Turns out there was a second power rail (connection) that the manual never mentioned. I found a connection labeled "ATX PWR 2". Connected a wire to it and presto! Thanks everyone.
by Jctech2025 Accepted solution
Second power rail!
So I got it got it working. Turns out there was a second power rail (connection) that the manual never mentioned. I found a connection labeled "ATX PWR 2". Connected a wire to it and presto! Thanks everyone.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending