11 replies
by jardinier
Did you reformat the Hard Drive before reinstalling the OS? Actually one of the first things Win 98 does on installation is install the mouse driver, because it is required to proceed with the installation.
Other than that, there is always the possibility of a faulty connection inside the computer, or even a defective mouse. Hope this helps a little.
by rwright17
by jim phelps
Find a mouse driver program; copy it to your hard drive. Then create a C:\AUTOEXEC.BAT file; and in this file, put a command to load the mouse driver program. Then restart the computer.
If you now have a mouse in Windows, then you will know that there is nothing wrong with your mouse. If you have no mouse in Windows, then you probably have a bad mouse or bad PS/2 port on the computer. In this case, try a known good mouse to narrow it down even further.
When you have solved the problem, you will want to get rid of the AUTOEXEC.BAT file you have created, or remove the MOUSE command from it if the AUTOEXEC.BAT file was already present. Having an AUTOEXEC.BAT or a CONFIG.SYS file will slow down Windows.
by amit_ser
Hi Jim,
Just do one thing check the mouse is Device manager Disable or Unistall it.Restart the Computer Now your mouse will be start Working.
Bye
Amit
by zzyp
When mouse fails, hard to navigete. You may need to brush up on keyboard commands if lacking a mouse and wanting to get to device manager.
Better, hold down CTRL key while booting, go into Safe mode. Mouse will probably work. Then go to Settings|Control Panel|open System|Device manager tab|, clic on "+" beside Mouse, Then hi-light mouse, click on "Remove" button at bottom of screen then reboot. On startup should recognize mouse and install mouse driver anew.
If mouse does not show in safe mode, may be defective.
One note, a PS/2 mouse must be plugged in when the computer powers up, otherwise won't work.
-Dale-
by amit_ser
Hi Jim,
Just do one thing check the mouse in Device manager Disable or Unistall it.Restart the Computer Now your mouse will be start Working.
Bye
Amit
by zzyp
It would help to know if the mouse works in Windows Safe Mode (hold down Ctrl key when booting). If so, then must be a Windows driver problem. If not, possibly a mouse hardware problem.
Also, is the mouse connected with a PS/2 plug (round slightly larger than pencil eraser in diameter) or Serial port (Trapezoid shape with rounded corners and 9 pins)?
If it is a PS/2 plug, it must be plugged in when the computer is powered up, will not work if plugged in after power turned on.
-zzyp-
by far_al
by dbucyk
Did you rewrite the code or just changed the users settings back.
If you didn't rewrite the code, just shutdown the computer and restart in MS-DOS mode.
Type scanreg /restore or scanreg/fix. The latter will fix the registry, but the scanreg /restore will restor the registry to an earlier date and unfortunately you'll lose users settings but it is a quick fix.
by zzyp
A little known quirk of a PS/2 mouse is that it must be plugged in before turning on the computer. If you turn on the computer and then plug in the mouse it will not work.
-ZZYP-
This discussion is closed to new replies.
Trending Peripheral posts
Sort by Trending