Discussion Locked

Windows 98 SE Startup Woes

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just bought a brand new 800MHz AMD Thunderbird PC w/128 MB RAM and a new Motherboard as well. My problem is that after loading or attempting to load the software for the Motherboard and rebooting, I receive this error message: " Error loading Explorer.exe. You must reinstall Windows " I lost my Windows 98 SE CD-ROM. Is there a way to fix this problem without having the CD-ROM ??? The new PC in question came with all the hardware except a Harddrive and OS. Please Help !!!

15 replies

by 16years

Sound like a problem I had with Win 98...every three to four weeks it would give me and Windows protection fault and would not start in regular mode, only safe.

It seems that there might be a problem with the hard drive. I had to reformat the drive to get it working again.

You will most likely need the CD to start the install fresh...make sure you wipe the drive clean first (low or mid level format) and then reinstall the OS.

by michbloch

Without the CD I don't see any way of correcting that error. That's a core component of Windows and it won't boot at all without it. Sounds like you need to reinstall.

by kevin brown

Without the CD you have very few options. You could try copying explorer.exe from another Win98 SE to floppy. Start in MSDOS mode and overwrite the existing file.

by master blaster

I had the same issue on a machine that was being re loaded, For some reason, I believe a bad CD, explorer.exe was corupted. I went to another machine running win 98 se and copied the Explorer.exe and then booted to DOS and overwrote the corupt file and she did boot back up and has run fine ever since. Good Luck !!!

by shanghai sam

Copying that file worked, I was able to boot into Windows and do some troulbeshooting. I think I have a bad harddrive anyway. Thanks for the tip !!

by cuziyq

Well, an easy way to get your system to boot would be to change your default shell. Open up your SYSTEM.INI file in a DOS text editor, and change the SHELL= line from EXPLORER.EXE to something like PROGMAN.EXE, or WINFILE.EXE (Remember good ol' Windows 3.1?) Any other program that you can use to manipulate files or run other rpograms would suffice on that line. This will allow you to boot, at least.

by chad dykstra

Just for kicks, you will want to check and see if the CAB (setup) files were installed on the PC when it was originally prepped. Could be in C:\Win98 or C:\Windows\Options\Cabs or a number of other places, depending on where the person who installed it put them. If they are there, you can run setup from them. Either reinstall, delete everything else off the partition then reinstall, or create another partition, copy the files to it, and then format your original partition. Good luck, hopefully you don't have to go buy a CD!

~Chad

This discussion is closed to new replies.