Discussion Locked

windows 98 shutdown

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When i shut down my win 98 sysytem it stops at the computer is shutting down screen, and goes no farther.I then need to hit the power botton, and when i start back up it starts scan disk and says computer was not shut down proper.

11 replies

by gregory w. smith

Microsoft's Windows Update site has a fix for this; also try running MSCONFIG and removing any duplicate "LoadPowerProfile" entries in the startup. NAV has a patch (sevinst.exe is the name, I think) and don't scan floppies on shutdown.

by syscokid

Hmm, it says there's one reply but I don't see any so I hope I'm not duplicating anyone's answer.

This is a well-known problem. If it's SE, sou need a patch. Check out http://support.microsoft.com/support/kb/articles/Q238/0/96.ASP for troubleshooting the shutdown problem and a link to the patch.

If you're not running SE, try Microsoft Knowledge Base article Q202633 - How to Troubleshoot Windows98 Shutdown Problems. There are at many possible causes for this so you'll just have to eliminate them one by one.

by boysun

Try downloading and installing all patchs for the operating system. If that doesn't help, it may be an indication that your memory is going bad. I have had this happen to a few machines and when I put new RAM in the problem went away. Hope this helps

by talon681

This may be a bit simplistic. but here it is.Go to Control Panel. Click on Sounds. search for Exit Windows and highlight None. For some installs of Win98 S.E. That event might cause a lock-up of Shut-Down process. I tried this on a couple of computers and it worked. Can't make any promises though because there may be host of other problems. Just thought this might help since I didn't see anyone else mentioning it.

by mrbigglesworth

I have two possible solutions to your question. number one: If you are on a network and have more than 5 mapped drive letters, windows 98 2nd edition will not shut down completely..ANSWER: go to microsoft dowloads, and pick the patch that fixes that..it will solve the problem if this applies to you. Second, some programs that you run on your machine is still hanging in memory when you try to shut it down...ANSWER: go to system devices, then to performance, virtual memory, and from their youwill see that windows is managing your virtual machine..click on the one where you are managing it, from thier it depends on the size of the hard drive..if it is a 10 gig har drive..and have lots of space left..i would use 20 for the minimum and 600for the maximum. After that restart the machine and run disk degfragmentor. And you should be good to go.

This discussion is closed to new replies.