9 replies
by syscokid
From what I understand, vxd's are machine-specific and created during Windows installation. By changing your hard drive, you've changed part of the system configuration so copying the OS from the old drive to the new is causing your problem. Thereare one or more vxd's that are no longer valid for your system. For more on vxd's see http://www.infinisource.com/techfiles/vmm32.html
I think you're going to have to reformat your new drive and do a clean install of Windows. Unless maybe you can run sfc from the command prompt? Don't know, never tried it.
Let's see what others think.
by technopat
by ramy naguib
by technopat
by tbradley
First, at your command prompt, type in
attrib -r -s -h msdos.sys
[Paths]
WinDir=
WinBootDir=
HostWinBootDrv=C
Ensure the following lines are there, and correct.
change the file back by attrib +s +r +h and reboot.
Run Fdisk at the c prompt, and using option 4, display partition information, ensure that the new drive, and the original drive are both fat32. If not, then that would cause the problem.
In this case, you will need to fdisk the new drive to match, then re-run the copy program, ensuring that drive compatibility is met.
also, while in fdisk, ensure that there are no other strange partitions on the drive.
Last, but not least, did you use the "drive overlay"utility to initialize the drive. It is unnecessary with win98SE, and will put a piece of code in the Kernel which would cause the error.
by technopat
by technopat
by technopat
by dmiles
One of the following may apply to change windows setup using the old drive
1)The Ifshlp.sys file is missing from the windows folder
2)The Config.sys file contains a line pointing to a previous version of the Ifshlp.sys file
3)The [Paths] section in the Msdos.sys file is incorrect
4)A winboot.ini file from a previous incomplete install is present in the root folder of theboot disk
1)For Windows 98,restart your computer,press and hold down the CNTRL Key-choose safe mode
Use text editor to open the Config.sys file
Remove the line that loads Ifshlp
Save and then close Config.Sys file
2)Incorrect [PATHS] section in Msdos.sys file
choose safe mode
Type following line at command prompt
attrib -s -h -r msdos.sys using text editor
3)Verify following lines in Msdos files
[PATH]
WinDir=
WinBoot Dir=
Host Win Boot DRV=C
For reference see microsoft knowledge base article Q139063
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending