Discussion Locked

Windows boxes on a routed network

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a network with 3 sites. The primary site has a Cisco 2600 series with 2-WAN ports. Each port is connected to a seperate remote site via dedicated ESF T1 lines. The remoted sites also have 2600's.

What is necessary to have the nodes on the remote workstations show up in Network Neighborhood, and vice versa? I have IP Directed-Broadcast enabled on all ports of all routers. But when at the remotes sites, I can't see the NT or Win2K servers at the main site. One of which has a printer that I need to connect to.

Brian

9 replies

by cavedweller

1. Make sure you are using the same routable protocol at all 3 sites and that your routers are configured to route it. Ususlly tcp/ip is a good choice.

2. Make sure that each node has a route defined. For tcp/ip you do this in the network control panel, protocol tab. Typically you would put the address in the default route entry. If you are using DHCP be sure that the correct routing information is being sent to the clients when they get their address.

3. Use the "route print" command to verify that the correct routes are being added. The "0.0.0.0" destination is your default route.

4. Test in stages. Can you ping your local router? Can you ping the remote router? Try telnet if ping is disabled.

5. Make sure you use consistant netmasks and broadcast addresses everywhere.

6. If you use multiple protocols, set the one you want to use for remote operation first in the list.

by brianaaa12

We are using strictly TCP/IP. We can ping any port of any router from anywhere. But the servers still don't show up in Network Neighborhood. We are also using TCP/IP app clients that work fine, so I don't think its a routing issue. Terminal services work fine also.

by the englishman

Check to see if in the advanaced properties of the TCP/IP connection the Enable NETBIOS over TCP/IP (for W2K) there is something similar for NT.

Also check where your Browser masters are there is a tool in the NT resource kit to check this

BROWMON.EXE - Select from the Diagnostics Resource Kit menu. The master browser will then be displayed for each domain. Double clicking on a machine will then list the other machines that are browsers and a subsequent double click on these machines will tell their status, e.g. backup browser.

Is the master browser machines are not your servers you might be having problems. NT usually sees the machines after approx 700 seconds.

by cisco_guy

Then there is no way to give you a precise answer! My bet would be that your using Frame Relay, which is a Non-Broadcast medium and would explain your browsing issues. In which case you would need to implement the "IP helper-address" command.

by brianaaa12

We are using the IP Helper-Address on the routers. I can tell you that the lines are Enhanced SuperFrame, full T1 between the sites.

This discussion is closed to new replies.