Discussion Locked

Windows NT 4

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My dell optiplex gxi computer stopped working; I was frozen. Turned computer off and rebooted. A blue screen came up saying dumping random memory see your administrator. Tried emergency disk in the A drive and went through the Windows NT setup. Still get the blue screen and same message. What happen? Is the blue screen of death that everyone talks about. Any suggestions?

2 replies

by jsoto

My personal opinion; reinstall Win Nt,
1. make sure you have enough memory.
2. make sure you have enough disk space for the pagefile.
Note: Problems ocurre when NT (Server or pc )run out of memory or pagefile is too small.
3. measure pagefilesusing Microsoft guidelines. should memory plus 50, may be 60

by paul

THERE ARE 5 PARTS TO AN NT STOP SCREEN
1.TOP RIGHT DEBUG PORT STATUS
2.BUG CHECK IE. ***STOP: 0x000000A
3.DRIVER INFORMATION IE. DLL BASE DATESTAMP
4.KERNAL BUILD NUMBER IE. ADDRESS DWORD DUMP
5. DEBUG PORT INFORMATION IE. RESTART AND SET RECOVERY OPTIONS
THERE ARE SOME DEBUGGERS IN NT TO HELP ANALISE THIS DATA BUT HEY IF YOU ARE NO THAT UP ON NT THEN I RECON YOU SHOULD LOOK UP TECHNET AT WWW.MICROSOFT.COM/TECHNET/ AND YOU SHOULD CHECK OUT STOP ERRORS OR STOP SCREENS USE THE ERROR CODE INPART 2 OF THE SCREEN TO SEE IF THERE IS ANY REF IN TECHNET.
YOUR DISCUSSION HAS VERY LITTLE INFO.
DID YOU LOAD UP ANYTHING LATELY.
WHAT SERVICE PACK ARE YOU RUNNING.
DID YOU INSTALL NEW SOFTWARE.
DID YOU TRY THE LAST KNOWN GOOD CONFIG
HAVE YOUTRIED VGA MODE

I GOT THIS ERROR ONCE WITH A STOP ERROR FROM HELL ON A PC BECAUSE THE IRQ WAS NOT SET FOR VGA CARD IN THE BIOS FUNNY ONE BUT HEY THATS COMPUTERS.
AND IT ONLY HAPPENED WHEN I SET UP THE DRIVERS FOR IT. IT WORKED FINE ON STANDARD VGA

This discussion is closed to new replies.