Discussion Locked

Windows protection error at startup

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am getting the Windows protection error at startup in both normal and safe mode as well as step by step confirmation. How can i troubleshoot this without replacing every hardware component? Should i be thinking software? Several fdisks and formats have given the same end result.

6 replies

by dft3

Swap out the RAM chips and try again. If you have more than one, then remove them one at a time and try it booting again. Repeat this until you identify the rogue chip.

I can almost guarantee that the problem you're having is due to bad RAM. You will seldom find that all of the them are bad; that's why I said one at a time. You'll probably have to replace or do without one.

If for some weird reason they all seem to be bad, then try new ones and if this persists, then more than likely, it's your motherboard.

I seriously doubt it's as serious as the motherboard, so try swapping the RAM first.

Good Luck!

by mmccaskill69

Try changing the settings of your BIOS to default.

Save and exit.

If the same issue comes up then it is your Ram or CPU (Possibly with overheating).

Good Luck!

by nettek

When starting Windows, hit F8 and have Windows log its startup process to bootlog.txt. You will then be able to view what failed to load, and this may give you an idea of the problem.

My inclination, since you have reformatted and reinstalled Windows, is that you have a hardware problem, or a real-mode driver problem. I do not think it is your RAM, since Windows protection errors usually indicate a driver problem.

I am assuming you can get to the Windows desktop in Safe Mode. Go to Device Manager. Go to the Properties of each of the following devices and check the box next to "Disable in this profile."

Com ports
Hard disk controllers
Floppy disk controllers
Display adapters
Mouse
Keyboard
Sound, video, and game controllers
SCSI controllers (if installed)
PCMCIA socket (if installed)
Network adapters (if installed)
This will cause Windows to start with only real-mode drivers.

Reboot. If Windows starts without a protection error, then the problem is with a protected-mode driver.

This discussion is closed to new replies.