windows-xp password

i forget my windows-xp start-up password
so how can i start my windows ( pc ) ?

http://home.eunet.no/pnordahl/ntpasswd/bootdisk.html
read up befor using, you can destroy the user account if used wrong.

Cracking a Windows (or other) PW...

First, gather these tools.
Philips screwdriver
Flathead screwdriver
torx screwdriver set (small)
Hammer
1/2" round unsheilded metal pipe.
spare HD

Ok, you will need to use a screwdriver to open the case on your computer. Pull out the HDD that has the PW stored on it (This works for all Windows and Linux machines). It is a bit crude, but the job gets done.
Now open up the spare HDD. This can be tricky, because some of the screws are covered with stickers. Also these screws will strip easily if the wrong screwdriver is used, so be careful.
Now, you must pull out the magnet in the second HDD. Attach the magnet to the first HDD (with the password to recover). Move the magnet around in a clockwise motion (or else it will be recovered backwards).
Now place the magnet back into the spare drive (which it came from).
this is the key that the HDD manufacturer does not want you to know.
Using the hammer, lightly hit the HDD where the nut is holding the platters together. If you can dent it (only a little) you will damage the protection chip housed underneath.

Put the HDD back together. Re-Install the original drive back into your case. Add the second drive as a slave drive (I like the USB option best though).

Start booting the system. You may hear strange sounds now, this is due to 2 reasons. First, the drive head on the slave drive is out of alignment and needs to be calibrated, so it will not let you boot. Second is because of the PW override.

Now we can begin the PW override process. Between the P and O keys on your keyboard (all keyboards since 1997) there is a small chip. Use the flathead screwdriver and lightly short it out. Your screen may flicker, this is normal if done properly. If not, keep plunging the screwdriver into the keyboard a little harder until the screen flickers.
You have just unlocked the PW/boot sequence menu in the BIOS. reboot the system, but before POST finishes, look on the monitor for the BIOS and REVISION #. On the B in the word BIOS, you need to tap this with the metal pipe a few times (usually 3, sometimes 2, sometimes 4). YOU MUST USE FORCE HERE. The B in the word BIOS is critical, you must 'touch' it. It changes quickly, so restart a few times to see where it is, then grab the hammer and rod and prepare it for the boot. Reboot and quickly hit the rod with the hammer.

To align the slave drive;
The HDD manufacturers do not want you to know this. They charge big bucks to do this themselves.
Get out the metal pipe. Holding the pipe in 1 hand, and the hammer in the other. Place the pipe near the power supply of the system. With the system 'on', hit the pipe with the hammer (hold onto the pipe well). Do Not let go. Dont hit too hard, you do not want to damage the PSU. All you want is the PSU to arc and send a spike of power through to the HDD. The HDD will automatically re-align itself. If it did not re-align, not enough force was used for the process to complete, do it again.

Reboot: Press the P & O keys on your keyboard simultaneously. Set the menu to either slave, SCSI, or USB PW and change the setting to ON.

There, you will automatically log in at will now. You can change the PW, if you want to, but no real need to anymore.