Discussion Locked

Windows XP Pro says no domain available

0 helpful
16 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
After changing out our old WIndows NT 4 server with a new Windows 2K. One of the workstations now will not log on. It says no domain available or account information incorrect. Also when disconnected it cant log on to itself ?

16 replies

by hberkhoff

Make sure the computeraccounts (of winxp pro workstations) exists on the new win2k server.

If not, create them. Otherwise get WinXp workstations to act in Workgroup, and after reboot connect them to the domain again.

by sgt_shultz

can you ping the server? if not, check tcpip settings (ip address, gateway)
you sure it is not connectivity issue? have you moved the computer to a known good network jack? tried logging in with domain admin password? tried another nic?

by terry.higgint

Check cabling and switch port - this message usually comes up when there is a communication problem.
I would think that when disconnected from the network no domains are available, since the PC is included in the domain list. You can still logon tothe PC as administrator, but only a 'dial up connection to your domain will be available.

by hunter

Try using the ping command to make sure you have connectivity. If so try the following:

This problem is more than likely a DNS issue. If your primary DNS server is not a dynamic setup then the XP machines are unable to register themselves in the directory. Since Active Directory uses DNS rather than netbios to resolve names you need to be sure it is set up correctly. If your Win2k server is not your primary DNS server you will need to add the DNS service to it and make it the primary DNS forall of the client machines. Then, add accounts for each of the machines or make it Dynamic and allow them to do it on thier own (I prefer Dynamic)

by rmckelvey

Thanks for the responses, I managed to unjoin the domain but now that XP pro station wont rejoin saying the following.......

"Multiple connections to a server or shared resource by the same user using more than one user name are not allowed "

I cant find this error anywhere on Microsoft site

by ctmoore1998

Is your 2000 server's DNS configured?? If you are running DNS install the support tools and run NETDIAG to insure that it is properly configured. Next are you STATIC IP or DYNAMIC? IF DHCP then make sure it is providing the proper information for IPand DNS (2000 server should be PRI DNS SVR)
If STATIC go into the NIC properties and check the IP configuration. Ensure that the IP, subnet and gateway information are correct and that the primary DNS server is set to the 2000 server you should then be able to join the domain and add the domain user to the workstation

by maholtz

You might need to drop the system to a workgroup. Sometimes you will need to kill the computer name (DNS host name)from the server. Then try to push it back onto the domain. If you cannot, you might need to uninstall networking completely and reload networking. Also see if the server can see the workstation from it's end.

by o.holmgren

GoodMorning. I think this problem is related to licenses. Have you checked number of cal:s configured on your Server?

This discussion is closed to new replies.