windows xp setup cannot create folder?
I can't think of a reason why but the xp installation setup always end when it is unable to create a folder ( windows\system32\config) this is to be the first folder created
w
Windows Forum
I can't think of a reason why but the xp installation setup always end when it is unable to create a folder ( windows\system32\config) this is to be the first folder created
w
by gary56789
Check here to make sure your computer's parts are compatible http://support.microsoft.com/kb/314062/
Next (as long as your hardware is compatible), do a Repair from the XP CD. When you get to the DOS prompt, type chkdsk /r, and then press ENTER.
After chkdsk finishes running, reboot and try the install once more. Let us know exactly what error messages you see if the install doesn't go properly.
by 3xp3rt
by hal 9000
Well in that case it sounds as if the install CD is damaged or the Optical drive can not read the Cd either way you'll need to have a close look at the CD and Optical Drive that you are using.
If the CD is damaged you can sometimes get by by making a copy of the Install Cd and then using the Work Copy but that one really depends on how badly damaged the original CD actually is.
The only other thing that springs to mind is that you are using SATA or SCSI drives and you need to install the correct driver to allow Windows to load on these drives you do this by pressing the F6 key when prompted at the beginning of the XP Setup procedure.
If you are using a plug in IDE or SATA controller card the same advice applies you need to install the drivers for the card which Windows sees as a "Mass Storage Device" much like a lot of SCSI devices.
Lets know how you get on.
Col
by hal 9000
by pierrejamme
Windows wants to be installed on C:\, but it will install on H:\ if you have USB stuff hanging from it when you install.
Are you sure your boot drive is C:\? It is very difficult to create a directory if boot is D:\, E:\, F:\ or H:\.
ashamed to admit it, but i just tried doing a fresh install on a replacement drive without removing all the peripherals attached through USB and I ended up with H:\windows and when i started restoring the drivers from the Resouce CD it couldn't create a directroy c:\Dell duh. Boy did I feel sttupid.
I hope this isn't your problem, but it's a thought.
PS I treied doing a repair after removing all the USB junk and it came up and said something similar to:
"Do you want to repair c:\Microsoft Windows System?" So I said yes and still had H:\ when it came back up. Worked fine, but not what I wanted. That must have been a Generic message and didn't really report the correct drive.
This discussion is closed to new replies.
Sort by Trending