26 replies
by sticknmuv Accepted solution
by sticknmuv Accepted solution
by sticknmuv Accepted solution
by sticknmuv Accepted solution
by robo_dev Accepted solution
by sticknmuv Accepted solution
by robo_dev Accepted solution
On the laptop, default the bios.
Try toggling video between external/internal.
Can you change video resolution in safe mode to 800x600?
Or change video drivers to generic vga?
If video card is failing, or video drivers are hosed.
by robo_dev Accepted solution
If it's nvidia quadro, there are lots of patches, as there are for bios:
http://www-307.ibm.com/pc/support/site.wss/document.do?lndocid=MIGR-67924
by sticknmuv Accepted solution
by robo_dev Accepted solution
If I understand correctly, the root cause was loading a USB/serial device driver, correct?
Perhaps that software is trying to launch a program at startup? In which case running MSCONFIG in safe mode will allow you to prevent the startup program from running.
In safe mode, can you go into control panel and remove the drivers added by the usb/serial device?
If not, then the next method would be to boot into recovery console and manually edit the registry to take those drivers out surgically.
by sticknmuv Accepted solution
by sticknmuv Accepted solution
by wesley.chin Accepted solution
by sticknmuv Accepted solution
McAfee Agent 4.5.0.1429
Host Intrusion Prevention 7.0.0.1159
McAfee SiteAdvisor Enterprise Plus 3.0.0.539
McAfee AntiSpyware Enterprise Module 8.7.0.129
by robo_dev Accepted solution
"swapped HDs from the original Lenovo T61 and put it into the new Lenovo T410. System booted but needed update drivers."
That "updating drivers" part is what killed your windows, I'm sure of it.
Windows Plug and Play probably changed your video drivers, your CPU driver, and maybe even added a couple of device drivers for the T410, just for good measure. Now when it's trying to undo all this back in the T61, it's having a stroke in the process.
At this point it may be faster to re-image the laptop versus forensically fixing whatever driver got hosed.
by robo_dev Accepted solution
When the drive was in the other computer, you installed the USB/Serial driver, correct?
Did you run some updates or add any other software at the same time the drive was in the other computer?
Unless the other PC is an exact clone of the T61, it's going to load the incorrect drivers via plug-and-play, and potentially mess up other settings.
by sticknmuv Accepted solution
by sticknmuv Accepted solution
by sticknmuv Accepted solution
by robo_dev Accepted solution
The risks are small, and the potential time savings are great.
I would recommend using a tool like Macrium reflect to make a disk-image of these laptops so they could be restored easily when this sort of problem happens.
by sticknmuv Accepted solution
by wesley.chin Accepted solution
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending