Question Locked

WinXP Problems recognizing USB devices at startup

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We have several systems that we're connecting two Keyspan USB to RS232 adapter cables to the available USB 2.0 ports. They install just fine and work as expected with no problems until the system is rebooted.

If the system is powered off for more than a minute the USB serial adapters are not recognized at startup by Windows XP unless they are unplugged and reconnected to the system. Then they work just fine until the system is rebooted again.

I've tried just about everything I could think of but can't get the system to reliably recognize the adapters if they are already connected when the system is booted. These systems are going into Kiosk applications and the adapters will not be accessible once inside the enclosure. Any ideas on how to get Windows to recognize the adapters all the time?

5 replies

by kincheah

You could try checking the existing drive mappings against the default USB drive. Clashes in the mapping will cause th e drive to be unrecognised

by onisick

I have an XP from work and a Vista 64-bit system running on Home Premium.

My old faithful brother HL-1660e (faithful on a parallel port) seems to be unrecognizable when I changed to a usb cable.

Let me know if you get answers.

by thumbsup2

If the drivers were installed when it was connected to a parallel cable, you need to uninstall and reinstall when connecting to a USB cable (or create a second printer with different name).

The port and communication settings are different between the two types of connections.

edited to add: You really should start your own question instead of replying to someone else's question. Your problem is different than the original question.

This discussion is closed to new replies.