Discussion Locked

wireless card - cardbus connection

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have 2 wireless cards that I have been using for over a year. Two days ago, upon inserting a card in my HP notebook and starting up, the wireless card was not recognized. The device manager says the cardbus is fine. I uninstalled and reinstalled and still have no connectivity.
Same result with a second card.

The WLAN settings in control panel/system says that I do not have a card inserted.

What could have happened? How can I fix it?

5 replies

by zaferus

Do other PCMCIA cards work? If not it could be the board or PCMCIA slot.

Is the wireless access point up and running?

by jrgordonga

Re answer 1 - I have no other pcmia cards other than the wireless cards (netgear wg511 and a non-branded Taiwanese long range card - both of which I have been using. Neither now work.
The last time I had power to the wireless card was on a visit to Kinko's - where I used an ethernet cable to print some reports.

by gary56789

When these types of connectivity problems occur, I always suspect Spyware. Hopefully you have a couple of spyware scanners on the laptop which are up-to-date. Do any scanning in safe Mode.

If you don't have the above updated on the laptop, you may have to reformat and reinstall unless you have the adapter to scan the hard drive from a desktop computer which has all of the above. You may still have to reinstall the OS.

by gary56789

Before reinstalling, search the internet for Winsock for your particular OS to see if yours will work after being rebuilt.

by josh

It sounds like the slots are messed up to me. Buy or obtain a new/working PCMCIA card of any type and put it in your slot. Install it and see if it functions as it should. If so, you know the slot is OK, and at that point can't look to other things as the problem (such as spyware, ect.), the card itself. Which you may want to clean the copper with a eraser of a pencil, just incase any oil residue from your hands got on the copper that connects it to the board.

This discussion is closed to new replies.