Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I see there is a place in the WCS to set up a wireless connection for visitors. I have tried the directions, but I must be missing some of the inital set up. Can someone elaborate on what is needed step by step to accomplish a wireless connection for visitors that is separate from our network?
3 replies
by jodiescherer Accepted solution
Clarifications
by robo_dev Accepted solution
TLA = Three Letter Acronym
WCS?
by seanferd Accepted solution
If so, Cisco provides all the documentation you need.
Perhaps if the OP were to elaborate on what is not working, or the steps taken as well as what else might be going on in the network... Because I don't think anyone is going to re-write all the documentation in hopes that it clarifies the missing bit. ;)
Wireshark might be a good tool, here. Or even Air Pcap or similar + Wireshark or your favorite analyzer.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies