Discussion Locked

ZEnworks design and planing

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

does anyone have any tips in implementing the new objects for Zenworks in the NDS tree.
as far as workstations and policies objects locations, based upon groups and user locations.

Please post your personal experiences.

thanks
jochoa@cchs.com

7 replies

by swilliam

the general rule of thumb is to keep the objects as close to the affected users as possible...

i have placed workstations in their own subcontainer relative to the users (i.e. users in test.central.corp would have their workstations imported intoworkstations.test.central.corp). i find it easier to manage and assign remote control rights with the systems in their own container.

as for policy packages, i place them in the same container as the affected users. this helps avoid tree-walking when applying them. if your users are spread out, try to pick the area held most in common in the tree or go with where the majority of the users are.

hope this helps!

by cmeisinger

I placed my user objects under my MIS OU under an OU called ZEN_Works_Admin. All the policies are here as well. This makes it easier for me to go through and make changes or do basic checks on their inventory and such. My users objects are locatedunder their specific OU such as Sales, Assistants, Officers etc... Any Applications I Snapshot I leave under my Servers OU.

Chris

by paul.haviland.ctr

I have the full zen2 and I place my workstation objects and policy objects in the container where the user objects are located. The closer any object is to the user helps performance

This discussion is closed to new replies.