Discussion Locked

2 HDs, 3 shown in my computer

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just got an Asus a7a266 and put the 2 HDs from my old sys on, running 98. Now it shows C: as the main drive, D: shows 0 used and 0 free, E: as my backup and personal stuff drive and the CDROM as F:. the drives were shared when the switch was made,that's all I can think of. there is also an "unknown device" I cannot figure out.
Any thoughts?
Thanx

12 replies

by bohicam1

I would take a look at how you did the cables on the drives. Were your two hard drives on one IDE cable before? Seems to me that you are slaving the cdrom off the second hard drive whereas in your old system you were slaving the second hard drive off the first hard drive. Since you did not wipe your system clean (or at least you did not mention it) the operating system is still looking for a drive in D:\
Good luck!

Mike

by brian

Maybe the unknown device is a disk controller?
I would try 2 things.
1. Try changing the unknown device to a disk controller. If this doesn't work, delete it.
2. Check bios to see that drives are all detected properly.

by brian

Actually the first thing I would do is look for updated drivers and bios for the Motherboard, but you may have already done this. I would make sure that I have the latest versions installed.

by tsimmo67

d drive is a compressed drive and it is only saying 0 used 0 free because Windows has made that drive contain compression files so windows can mount it.

there is a program caled drive space which is a compression tool which comes with windows andif you run this you should be able to rectify the problem.
-Travis

by mdevans_99

Boot into safe mode and look in device manager for any duplicate hardware. Delete any you see and reboot. Windows should find any legitimate devices.

by b.scott1

Boot to DOS or use a boot disk and do a FDISK on the main drive. Check to see how your partitions are set. You may have a primary partition as drive C: and another partition as drive D: which is why Windows is reporting it as two drives. You may just have to delete the D: partition. Be careful, if you don't pay attention to the prompts you may end up deleting your hard drive as you cahnge the partition information.

by mackzx

I debugged, FDISKed and formatted the second drive, after backing it up of course. All is fine now.

This discussion is closed to new replies.