Discussion Locked

2000 Server OS Slow Printing First Job

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Dell OptiPlex 110 that has 2000 Server installed that I use for a test server. It only has 128 MEG I have order another 256 MEG of RAM I know 128 is not enough.

The question: Why is my Server 2000 OS very slow to open files from withinExcel 97 from our Novell File Server? What Can I do to fix the problem.

Also, why is the first print job from within Excel to our HP5 SI network printer is very slow? Whereas, the next job to the printer takes about the same amount of time asit does my Windows 95 PC. I suspect if I print within 10 minutes of the first job it will print quickly. Thus, I suspect I have set something wrong somewhere, but I don't know where?

Our local IT support staff has not been able to solve the problem, and in fact that have also encountered the same problem.

I am using the Novel Client NT/2000 from July 31, 2000 on the 2000 Server PC. Any suggestions will be appreciated.

5 replies

by qb

For the printer try going into the properties and changeing the settings on the advanced tab to start printing immediately. instead of print after last page is spooled. I believe the memory will help clear up your file access problem.

by daryl_reese

I was unable to find the start printing immediately option within the Advanced Tab. I have seen this option on other print drivers but not the one for Server 2000 for the HP5SI. Perhaps we have the wrong print driver? Thanks for your suggestion. Unfortunately I was unable to implement it with the existing driver.

Furthermore, when I go to printers and Right-click the network printer (HP5SI) I get the following error. "The instruction at "0x775d6c79" referenced memory at "0x00000000" the memory could not be "read". This was after I had the IS team install another 256 M of RAM from Dell. Prior to this it would just "HANG" and not do anything when I would right click on the printer.

by umbral-echo

You should fix your RAM deficiency before you look for other answers to these problems. Remember that when you print a portion of memory is used to spool the print job into the printer language before sending it to the printer. If you have a RAM crunch, the computer compensates by madly swapping dormant code from physical memory to the hard drive. After you have used it once, the printer spooler will already occupy the much faster RAM until it gets bumped out by something else.

In addition, files that are downloaded from the network are cached in - you guessed it - RAM which will suffer terribly in performance if the Server is busy doing other things. Until you have removed the RAM bottleneck you wont be able to effectively troubleshootthis problem.

by daryl_reese

I have added an additional 256M without any change in the printer response time. I have also installed SR-2 without any noticable change.

This discussion is closed to new replies.