8 replies
by mpdcsup
"I removed NT from my PC and reinstalled 98. Now my drives are partitioned (I have 2 hard drives)and the 1st one is partioned into drive C and D. NT is on C."
I thought you removed NT from your PC.
"98 is on D. I can't get access to G (2nd drive)."
Was G (2nd drive) NTFS?
"Also says at boot I am missing msnp32.dll. I copied back into D and still same error message."
How large is the first partition on the first drive? Non-FAT32 FAT partitions are limited to 2GB and must be completely contained in the first 1024 cylinders. Non-FAT32 FAT partitions are the only partitions accessible to both Win9x & WinNT.
My USB ports won't activate my webcam/camera. Downloded new drivers from manuf. Still doesn't work. USB shows power in Device Mgr but camera doesn't light. Also, also at boot my system.ini points to 3 different vxd files but device is not present.
by mpdcsup
by nvpaladin
by dmiles
1)If the first partition is NT and you are using a NTFS partition and this is the active boot partition,and G is 98 with fat 32 you will not see the drive at C unless you have WIN 2000 which will read fat 32,you can see the drive in NT by opening windows explorer.
2)MSNP.32DLL-is a microsoft network protocol that by going into Control Panel-click on ADD/REMOVE Programs and select the Windows SetUp Tab,highlight Communications and click the details button,you will uncheck dial-up networking andhit okay,donot restart,go back to windows setup and then put the check mark back in the dialup networking box and click apply and OK and yes to restart.
If this does not work then you will have to want to remove Client For Microsoft Networks and reinstall.
These files were loaded from previous installs and you may want to delete them if they are no longer needed.
Determine if you are using NT or WIN98 drivers,which directory do you have files loaded in.Hope this helps
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending