Question Locked

A Non - Booter!!!!!

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello, this is my problem:
I purchased a new case and swapped all hardware accross from the old to the new. Turned on the power and nothing! All fans spin (cpu,graphics,case,psu) and the hard drive spins into action. But nothing, no beeps and no diaplay on the monitor.This system was working perfectly until the new build. Any ideas??

All connections have been doubled checked and checked again. All components have been checked. new ram has been tried and also a new graphics card, still nothing. Have stripped to the bare bones to single out a component, but nothing.

Oh, and there seems to be no power to the cd drive when the ide ribbon cable is fitted, removing this gives power to the cd drive!
im confused!

I'm running XP2 on an AMD Athlon 1.8 Ghz with 1GB of RAM.

4 replies

by mjd420nova

I've seen this problem before, and it was the IDE cable had been reversed, or plugged in backwards. There should be a notch in the connector on the cable and a slot in the mating connector on both the system board IDE connector and on the drive itself. The ribbon cable should also have a stripe on it, this denotes the #1 pin and should be oriented on the drive closest to the power connection. Look closely at the system board to find the #1 pin mark on the board. When you dissassembled the old unit, did you notice any insulating washers on the underside of the board?? If you missed that, it could be shorting out on the standoff. Good luck

by craigbasnett

Thank you so much good man, you have solved my problem on the first attempt.

romoving the motherboard for the 3rd time revield the little bugger! it was a stand off shorting out the motherboard!

thanks again craig

by mjd420nova

This has become a real common problem, overlooked by even some of the sharpest techs. Difficult to locate, and even harder to find if you're not the builder. MY own experience has been when building units is to replace those standoffs with nylon or plastic, then it doesn't matter.

This discussion is closed to new replies.