Discussion Locked

A very Typical FDD problem in WIN2K

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

If I insert any Floppy, the FDD can read any data from it and can copy on HDD. But when I try to write on the Floppy it gives the following msg:

Error copying File or Folder
Cannot copy image: The disk is write protected.
Remove the Write-protection or use another disk.
This msg is given for all FDD installed on this
PC.
Can anyone help? is it a registry problem or is it a data cable problem ?
Thanks
MZR Siddiquee

4 replies

by thechas

2 things to check:

In BIOS settings, check for write enable for the floppy drive.

The actual setting and description varies by BIOS, but many do have a setting that disables the ability to write to the floppy.

Next, I would suspect the actual drive itself over the cable for a hardware issue. It is possible that the switch that detects the write protect tab on the floppy is stuck or broken and reports a write protected disk.

Chas

by jimboj

Definatly sounds like a hardware issue rather than software, i would suggest changing the FDD Cable first if not floppy drive.

Have you tried copying data in dos rather than windows to eliminate this problem.

by ctmoore1998

Check the sliding tab on the disk itself. If the hole is covered it is 'write protected' Next check your system bios lots of them have the ability to set the floppy to read only.

This discussion is closed to new replies.