Discussion Locked

accessible w98 ws can't see server

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Windows 98 workstation resources accessible to entire 5 station network but cannot access any other mach on network. In Windows explorer it sees mapped drive and opens folder on server but will not open a file. Network neigborhood shows machines after about 5 minutes or times out. Have tried using tcp/ip with no address, netbui and both at same time. Help.

8 replies

by chuck

First,,How are the PC's linked together ?
Server, or just a hub ?
Are you utilizing MS Peer-to-Peer ?

by rabbit_runner

My suggestion is to use only one protocol. You are using tcp/ip (with no address) and netbeui. Use one, or the other. I have seen where both are used, this can cause too much traffic on the network to allow quick connections.
Next, Check the NIC's on each computer. There are normally, two lights. These are small tiny lights right where the network cable connects into the back of the PC. there should be one green light that is always on. This is a 'link' light that lets you know the computeris connected to the rest of the network. Beside that there may be another light (green or amber). This will show network activity. If you have one PC that has constant or continious activity, you may have a faulty NIC. Re-seat or replace that NIC.
If you use tcp/ip, you must assign an ip address to each computer. common tcp/ip addresses are....
192.168.1.x subnet mask 255.255.255.0
10.10.10.x Subnet mask 255.255.255.0
The 'x' is a number that you select. It will be from 1-254. But each PC must have a different number.
Next, check the workgroup. The workgroup on each computer must be the same. What you did not say in your question, is whether you are using a DOMAIN. If you do not know what I am talking about, do not worry about it. But if you understand, then make certain each pc is a member of that domain.
Lastly, there are other things to check, but I would need additional information about your systems and network. If you want, contact me and we can discuss this further.

by pcsense

This is an MS peer to peer network using cat5 cable connected to an 8 port 10/100 hub and a non-dedicated server in a workgroup. The problem workstation (and its resources) is completely available to the rest of the network. This workstation cannot access any other shared resource on the network.

by nettek

Browsing is very quirky in Win 9x without the benefit of a WINs server. Try the following:

Limit the number of Browse Masters to the two PCs that are up and running on your peer-to-peer most often. Set the others to Disabled under Network Neighborhood -> Properties -> File and Print Sharing -> Properties.

If that does not help, on the PC that has the empty Network Neighborhood:
1. Open Network Neighborhood.
2. Go to Start -> Find -> Computer, and find one of the missing PCs.
3. Once found, drag and drop it from the Find window into Network Neighborhood. You will be asked if you want to create a shortcut. Click Yes.
4. Repeat the process for the other missing workstations.
The PCs should remain in Network Neighborhood after reboot.

Not ideal, but it works. Hope that helps.

This discussion is closed to new replies.