Desktop

Ask something
Discussion Locked

Accessing slave drive

0 helpful
2 replies

by docuementor 1 view

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a master drive (1.0GB that came with the PB Legend 3100) & installed a slave drive (WD AC 6.4GB). I have had to reinstall my operating system & now it doesn't recognize my slave hard drive. How could I get it recognize the slave drive WITHOUThaving to lose all the data on the drive, or without having to reconfigure the drive?

2 replies

by rmed

Hi!
First, look at the correct switch position on the rear of your slave HDD. Then go to bios setup and select "IDE HARD DISK DETECTION". After detection choose "SAVE AND EXIT SETUP" and reboot.

Good luck

This discussion is closed to new replies.