Question Locked

Accidental use of 120 VAC adapter on 240 VAC

0 helpful
21 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My client took his Gateway M-152S laptop to Ireland. He plugged his laptop power adapter into what looked like a 120 VAC outlet. It wasn't. It was 240 VAC. He thinks "he fried it."
My questions are, 1)would the AC adapter blow first? 2)would the laptop battery act as a buffer long enough to protect the laptop itself from damage? 3)if neither of the above, would the hard drive possibly survive? Apart from buying a new adapter to see if the battery is OK and a new battery to find out if the laptop is OK, what other steps could I take?

Any help would be appreciated.

21 replies

by peconet tietokoneet

But saying that it depends on the Ac adapter, all you have to do is connect it and do a test with a good multimeter and see if it reads anything.
If you do not get a read out then you will know for sure. Just in case purchase another Ac adapter and do a test, if all goes well then it would be the old adapter, if not then you will have to purchase another battery. The cheapest route would be a new Ac adapter and go from there.

by rovoco

Thank you for your rapid reply. I had planned on doing what you suggested first.
Is there any way to test the battery outside of the laptop, or are all the pin connections different for each model?

by peconet tietokoneet

Inside of the Ac adapter there are components that register voltage so in theory these components will/should blow first.

by thechas

There are many combinations of connections to laptop batteries.

If you have the service manual, you should be able to identify which contacts are what.

As an alternate, battery stores like Batteries Plus can test the battery for you.

Chas

by oldbaritone

Solid-state devices work on "magic smoke" - the factory seals the smoke inside the chip, and if you break the "smoke seal", the magic smoke escapes and the chip doesn't work any more.

When he plugged a 120V device into a 240V outlet, he probably broke the "smoke seal."

Most computers have well-protected power supplies and well-protected power input plugs, so there's a good chance that he'll get lucky, and only the power supply is fried. No guarantees, but hopefully dumb-luck.

Tell him with the new power supply, in addition to the surge suppressor, he should invest in an I-D-TEN-T protector, too.

;-)

by kenone

nosmoke.exe for that user. have the user run it frequently

by tintoman

I mean, you come on here to get advice on a problem right? all this bull about smoked chips and smoke.exe is utter nonsense.
As anyone who knows anything about basic electronics will tell you, if you feed an electronic device with any voltage other than that which it was designed for the results will usually be devastating. In your case since the supply voltage was much lower than it should have been the resultant current flow will be much higher than it should be, after that it's a matter of which is the weakest point where the burn out will occur.
So P.T's reassurance that your "laptop will be fine" is a wild theory at best, and rediculous remark at worst, furthermore why on earth would you go and buy a new adapter before you test the old one? even if the old one continues to produce the correct voltage now it's no guarantee that the laptop isn't fried.
Sometimes I really do despair.........

by thechas

As one who knows more than a bit about power supply design, in the described situation, the power supply should be the first to fail.

If the design is good, the failure mode is a fuse or fusible link inside the power pack itself.

Now, if the design is not an optimum design, the switch mode regulator could fail in a mode that would place a high voltage on the DC output. Then, a fuse or over-voltage protection circuit in the laptop should open the circuit and limit damage.

Still, to pass testing and get a UL rating, the power adapter has to either survive an over-voltage, or at least fail in a safe manner.

If the laptop does not run off of the battery, the laptop may need a repair (probable minor) and a new adapter.

Worst case for the hard drive, is that even if the electronics are fried one should be able to recover the data by swapping the hard drive electronics with a working identical drive.

Chas

by oh smeg

What does the Power Adapter say on it?

All of the new NB Power Adapters that i have seen recently well over the past 2 or 3 years all have been Auto Switching Dual Voltage so they should work perfectly no matter what they are plugged into.

But I do agree with the others here if it was just a 120 V adapter it should have fried immediately and if it meet a half way decent Design it would not have passed any charge tot he NB itself. It should have been fairly spectacular though and it's something that the owner would have known about immediately.

However what does happen and what should Happen are quite often different stories so the only way to see is to grab another charged battery and see if the NB works with a fully Charged Battery and if that doesn't work remove the HDD and try it on a USB SATA?IDE Cable and see if you can get to read it.

Of course if they where using some form of Encryption it may prove very hard to recover any Data off the HDD. If that is the case here the only real alternative is to send the drive straight to one of the Data Recovery Specialists who can recover Encrypted Data in a usable form. ;)

Just a note for your Client when you visit other countries most have a different Mains Voltage to the US and all British Colonies or Past Colonies use the 240 V system. They [b]Do Not[/b] provide 120 V no matter what the plug looks like it is always the clients responsibility to provide the right transformer to step down the Local Voltage to their electrical Devices. ;)

Col

by santeewelding

Yeah. I've been following this saga (dumb thing I'm electrically capable of doing myself) and I see no mention of the unforgettable sound, and smell, of the electrically awry.

by oh smeg

Plugging a 32 V Sewing machine into a 240 V Socket and pressing the go peddle.

That was interesting and should never have happened but who ever converted it to 32 V didn't put a 32 V plug on it or change the Specification Plate. If I had of found out which dealer did it it would have cost them their dealership. Even if it didn't do any real damage other than scraping off a bit of paint and blowing the 32 V light bulb.It was still downright dangerous. ;)

Col

by bodonnell11

I am reminded of the time I plugged in a compaq presario to 240VAC power while I had accidentally left the machine's power switched to 120VAC. She kinda went poof and bang and sparks flew. The power box was well and truly fried. Past that nothing was hurt. So my answer is that the adapter is probably well and truly fried. The battery may or may not need replacing and the rest of the machine is probably AOK. Try replacing the adapter first then try the next in the line of fire. The laptop can probably be salvaged inclusive of the contents of the hard drive with a minimum of fuss, bother and money (but I would charge an arm and a leg for doing the job).

by rovoco

Thanks to everyone who responded to this post and the helpful suggestions! I am very glad to be a user of TechRepublic's help forum. You guys are great! I shall see the client this weekend and post the final results to this thread for your information.

by oh smeg

But with even a modicum of luck it shouldn't be as bad as you first thought. ;)

Col

by rovoco

As promised, I am reporting to all who responded to this thread with their helpful suggestions that my client had used "the wrong power adapter" and had apparently blown that one, rather than the adapter that came with his laptop. The correct adapter
works fine, as does his laptop. He was very lucky and I told him so. Thanks again for all your comments!

by thechas

It's always good to know how a problem turned out.

Thank you for letting us know.

Chas

This discussion is closed to new replies.