Question Locked

Activating A Mirror Drive

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Compaq ML350 G1 with mirror drives that the main one failed. What is needed to activate the mirror drive? Can I just run windisk or should I use Smart Start?

3 replies

by churdoo

ML350 I believe has hardware RAID out of the box, but the fact that you're even asking this question makes me think that this is a software RAID. Which is it?

You should not have to use smartstart. If hardware RAID, it will tell you during POST, which drive is bad and you can go into the ROM-based ACU to confirm the remaining drive(s) are OK, and then you can replace the failed drive, and the RAID controller should start the rebuild automatically.

If Software RAID, need to know the O/S. G1 is a circa 2000 server is it not? So what O/S are we talking about?

If in doubt, don't mess with it; either call HP support or post back.

by internetranking

It is using a Server Features Board (Video, NIC, SCSI Controller all in one) on NT4 platform. No where during POST does reflect that a drive is bad or good.

This discussion is closed to new replies.