Discussion Locked

Active Directory

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I setup a Windows 2000 Server with 5 nodes. I want to use Active Directory for security reasons rather than run in a Workgroup setting. However, AD asks for a DNS name when setting up. How do I properly setup AD for use on the network? Of the books I have read, none are clearcut. With NT I didn't have security issues and all users had to login properly to access the network. Please HELP!

7 replies

by philip reay

Hi

Unfortunately, setting up a domain for users to login is not as clear cut as what NT was. For starters, Windows 2000 WILL NOT/NEVER install Active directory without some sort of DNS structure already in place within you company. You can install a DNS and leave it out of your daily use, but this may cause problems.

In order for you to set up AD you shoudl do the following:

1. On the windows 2000 server, install a DNS server.

2. Create a forward lookup zone for you company (This can be internal or an external zone.. its up to you) eg. Mycompany.com

3. Create the Reverse lookup zone for you network (eg. 10.113.0.0)

4. Create all relevant host and record entries within the forward lookup zone and ensure that you have the create PTR record checked when doing so

5. Configure the DNS entries on the all clients to point to the right zone and dns server

6. Ensure that you have configured the name of you server correctly...right click My Computer, select Network ID tab, select properties, select more and ensure that the FQDN is correct eg. mycompany.com

7 Right click on both you zone files and enable dynamic updates.

Check you DNS server by typing:
NSLookup at the command prompt and typing the following
mycompany.com check IP right
mycompany.com IP check name is right
someotherhost check IP right

Now proceed to install AD, and when asked for domain type in the name of your forward lookup domain.

I know this is very high level, but if you need more help, you can contact me personally.

Cheers
Philip

by briantruitt

Phillip is right on. AD will not work without DNS. When you run dcpromo.exe and start the AD setup wizard, it will prompt you for a DNS server. If you don't have one the wizard will help you set one up, just in case you're not too familiar with setting one up manually. The forward lookup zone is mandatory and the reverse lookup zone is optional, but it is a good idea to set it up as well while you're at it. I know that you already probably know this, but just a reminder, make sure the domain name you start with in AD is the one you want to stay with. The only way you can change it is to uninstall AD and start all over again. Good Luck.

by zrclshn

I agree that Philip is correct; however, Brian's way of letting the AD wizard setup your DNS is the best way to go. The only addtion I have is in Win2k, the Domain Nameing scheme is different than what it was in NT4. the Domain name must be in theformat of ****.Domain Name.***, if you have been provided a true Domain Name then use this, i.e www.yahoo.com, otherwise, just use www.Domain Name.com keeping in mind that in some aspects the domain will be refered to as the entire www.domain name.com, and others just by the domain name i.e. in network neighborhood.

Shane

This discussion is closed to new replies.