Discussion Locked

adaptec error

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I rebooted my NT Server after applying sp6 and I am getting the following message when the Scsi card is recognizing the the first scsi drive---start unit request fail. NT will not boot.

5 replies

by karsudha

hi friend,

this is a known issue with adaptec controllers. during the sp installation u will be prompted to upgrade the scsi driver. if u say yes AIC78XX.SYS will be overwritten.
this file is different in nt4 & sp. so if u have repair disk use it and reinstall sp again and say no to over write the file.

hope this will help you. this is the method i used for my adaptec 7800 series controller. there is a kb article on this but i don't remember the number.all the best.

by estebandelatorre

Boot from instalation cd rom, choose repair, insert erd disk, overwrite all files, boot and install the previous sp.
to load sp6a
First upgrade your drivers or choose no to the upgrade prompt message under sp instalation

This discussion is closed to new replies.