8 replies
by curlergirl
by curlergirl
by duskos
Actually, you can add your Win 2000 server as a domain controller (DC) to your network, but in that case Win2000 server becomes the "master" DC on yor network.
I have done it and it worked for me, maybe it will work for you as well.
Step 1
Install Windows NT 4.0 with Service Pack 6a to your new server. Chose to configure this server as a backup domain controller (BDC).
Step 2
Promote your new NT server to become Primary Domain Controller (PDC).
Step 3
Upgrade your new NT 4.0 PDC server to Windows 2000 server. Your new Win 2000 server will become the Active Directory Controller for your network. Your old BDC's will work with no problem as BDC's, but you'll not be able to make them PDC's again as long as you have Win2000 DC's.
Install Windows 2000 Service Pack 1 as well.
Step 4
Upgrade your existing NT 4.0 BDC's to Win 2000. When you upgrade the last NT 4.0 BDC, you can switch your Windows 2000 domain to native mode which gives you more options with configuring your domain. When you upgrade NT 4.0 BDC's to Win2000, you don't need to make them all domain controllers.
As long as you dont want to setup Active Directory, you should have no issues adding the server as a member server. Win2K cannot function as a BDC in an NT4 domain, it must run Active directory if it is configured as a Domain Controller.
Answer two does step you through making this server into a AD server, but one note: You must use DNS with AD, which might take a little extra knowledge if you havent setup DNS before.
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending