Discussion Locked

adding a new domain controller to W2k

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a W2K domain controller with active directory on it and want to install another W2K domain controller on network to run DNS on it, the existing domain controller is over taxed, if I install another W2K DC to run DNS how will it affect the existing domain setup? am new to this, any help is appreciated

3 replies

by lordinfidel

There are several steps to doing this, but it can be done.

FYI- Your win2k dns server does not have to be a domain controller. It only has to allow for dynamic updates.

If you really want another DC, especially for redundancy purposes.

On the new 2k server, run dcpromo (start/run/dcpromo) Enter the new DC into the same domain.

Once AD is installed on the new DC, Make sure you go to Sites And Services and set it up in there (site links, etc)

If you want this to be a DC that can also be a Global Catalog server, you enable that in Sites and Services under NTDS for that server.

(I would do this next part when your network is not being used and all users are of the network)

Once That is all set up, install DNS on the new server. Get your initial zone records correct. Only put in hosts that have static entries. Make sure that it is set up to accept dynamic updates.

Once your DNS is working on the new server. You will need to point your clients to the new DNS server. Do not forget to point any statically mapped ip clients to the new dns server.

Reboot your old DC and any other computers that had static IP's. This way they register themselves in the new DNS.

I suggest getting this book.

Inside Windows 2000 server by William Boswell, published by New Riders.

This discussion is closed to new replies.