Discussion Locked

Adding a PDC to a domain

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am adding a new server to the network which I will use as a PDC. I am having trouble promoting it from BDC to PDC status. I get error messages saying that I need to synchronize server although this has been done numerously. If I shut down the PDC,I can then promote the BDC but then get event viewer messages netlogon messages saying the server and other PC's have lost their SID's. I do not want to have to recreate new computer accounts on the network.
Does anyone have any ideas/comments

7 replies

by tdemanmsmvp

Hi.
I think that you have two servers claiming to be PDC of the same domain.

Some parts are strange in your presentation.
You say that you use a PDC, and you cannot promote it to PDC.

In reality, you must install your new server as BDC of the existing domain. After this point you will be able to promote it as PDC as a normal thing.

As I understand your problem, you want to promote as PDC a server coming from another domain. For security and SID reasons, this is not possible.

In all cases, to verify the situation:
Use DOMMON.exe from NT Reskit to verify that BDC and PDC are synchronous.
Use Server Manager to promote the BDC.

If you cannot easily promote PDC in your domain, that signify that the BDC has not been well installed.

Bye.

by tonyp_fno

I would think that something is really wrong with the installation on the new server. Wrong domain, wrong setting or just something went bad during the installation. You might want to try reinstalling the service pack you are using and trying again.
However, this should be a pretty straight forward afair unless the BDC was used in another domain in which case I believe you have to do a new install. If that is not the case this all should be pretty simple. But it sounds like when you say new you mean new within the domain which to me would explain why you are having these problems. Changing the domain name will make it appears as if the server is working within the domain but in actuallity it is not. So in summation I think the quickest most direct thing to do is just reinstall NT.

by russell.pentz

I think that reinstalling NT server is the best for time but not for knowledge of what has occured.
Thanx anyway

by evansgrmj

Did you install the server while it was attached to the network? If not, then you will have to reinstall. Even though you have the same domain name, it is treated as a different domain because of different SID's. Install the server as a BDC while it is connected to the network, then promote it to PDC after synchronization.

I hope this helps.

This discussion is closed to new replies.