Question Locked

Advice on RAID setup with 2 SATA Hard drives

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a small foot print tower with a SATA Hard drive installed. I decided to purchase an external (since it wont fit in the tower)SATA HDD for back up purposes. I discovered that my mother board had only 1 SATA port on it, so I purchased the Belkin SATA II RAID 2-port (1 internal/ 1 external PCI Express card. Unfortunately, after getting the card and installing it I realized that I can not use the internal port. Due to the location of the port on the card, if I connect my HDD then I can't put the cover back on my tower. So I have it configured like this. The internal HDD is connected to the SATA port on the motherboard and my external SATA HDD connected the eSATA port on the RAID PCI Express card. How can I set this up to mirror my internal HDD? Or can I even do this? Any advice will be greatly appreciated. Thanks!

2 replies

by hal 9000

It's better to only have the external HDD running when it's needed rather than all the time as they get hot and will eventually die faster than if mounted inside a case.

As to your question of Is it possible the answer would be [b]Probably Yes.[/b]

But there is no advantage in doing this so I would suggest that you just run the internal SATA Drive and use the external one for Backup Purposes as while it would be nice to have a Mirror Array every time that you shut down the external drive you'll get a HDD Failure message from the RAID Controller and when you turn it back on it will not necessarily rewrite the entire changes that have happened since it was last turned on unless you go through a Rebuild Process every time that you turn on the external drive.

As for the SATA Port on the PCI card there are different SATA Data leads that may allow you to use the second connection on the Card but the moment that you connect the internal drive to that the system will no longer Boot as the drivers for the PCI Card will not be in the Boot Sequence so as far as the computer is concerned you will not have a HDD to boot from.

It's much better just performing a backup on a routine basis and not attempt to setup a RAID.

Col

This discussion is closed to new replies.