Discussion Locked

Apps run sluggish on NT Server

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Background - We run an application that combines the use of Parodox database with Autocad for design work. These applications run on an NT server 4.0. We reloaded the OS because we needed to repartition the hard drives. After installing and patching the server, and restoring the files, communication between users and the server is severely sluggish. The time it takes to open or save files has gone from 5-10 seconds to 45-60 seconds or even longer? Any help would be appreciated.

9 replies

by spydergst1

After installing Service Pack 4 or higher, you may notice that your network seems to have slowed down. This is because of a change that Microsoft made to the RDR.sys file that increases network traffic. This fix was for a problem with handles being invalidated when a dismount occurs. While Microsoft is likely to fix this problem in SP7, you can address it now with the following registry change: [HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Rdr\Parameters] "FileSystemControlFilter"=dword:00000000.

Also, I experienced this problem before. We had to set the NIC on the server to full duplex. This worked. Our router was configured to run full duplex and the nic was set to auto or half. I can't remember which.

On the client side verify the wins, gateway and dns settings. be sure to configure the dns suffix search order if the server's primary dns is different from the client. Hope this helps.

by chad dykstra

I had this on an NT4 server once - I believe I installed the NetBEUI protocol and it sped up drastically...verify the protocol settings are the same on the server/workstation. Maybe check your Task Manager and see if anything is gobbling up memory or resources also and try to figure out what it is from there.

GL!

~Chad

by dbowlin

I had a similar problem. I came across an MS knowledge base article which described a TCP/IP problem called "nagling." The article stated that there was a problem between the TCP/IP stacks on different service packs. Without relating the 100+ page white paper on the subject and the TCP/IP stack, the fix was to have the workstations and the server at the same service pack level. When I put my workstations and servers all to SP6a the problem was solved.

Good luck,

by estebandelatorre

As long as you repartitioned the drives, I recommed you trying to set a pagefile for EVERY new drive created!.
Go to Control panel / system / Performance / Virtual Disk, and create new swap files for every drive

This discussion is closed to new replies.