Discussion Locked

ArcserveIT and HP Autoloader 718E proble

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Installed HP Autoloader on NT Server 4.0 running Lotus Notes in our London Englan office and installed Arcserve 6.61. Tape backup constantly broadcast "Tape alert detected" warning although tape unit backs up and restores OK. Spoke to Arcserve TechSupport who suggested installing Service Pack 1, rebooting server and/or downgrade the firmware on tape drive to 2.05 from 2.07, as Arcserve 6.61 is only certified to 2.05?
Spoke to HP Tech Support, told me to install the HP TapeDrive Software andrun the Library Support Tools to test connectivity. Ran on the Tape Drive and Autoloader, and both tested OK.
We run the same configuration on two servers in the US and they run fine.
Any suggestions?
Thanks
Bill Hansen
bhansen@broadview.com

2 replies

by bpalmer

We run a Compaq DLT tape library with ArcserveIT. Only time I got a tape alert on it I just used a different tape and it went away. Assuming you've tried that. Is there anything different between the US setups and the London one? Server patches/system software revs, tape library revs, Arcserve patches? They can be very picky sometimes... both the Hp drives and Arcserve...

by hansen_william

After going through the usual as you outlined, they suggested running this with the downgraded firmware, which we have not tried yet.

Thanks for the thought.

This discussion is closed to new replies.