Question Locked

ASUS PSGD1 motherboard/sata hdd problems

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have an asus psgd1 motherboard, but when i try to turn it on, (with everything installed, psu, sata hdd, agp card, ram, etc.) it doesnt start up. the fans start to turn but then the computer shuts off. if i unplug the power to the sata hdd, the computer will boot, but then it will shut off because there is no hard drive. why is it acting like this? its not the power supply, because i tried other ones with different mobos with the same result. what is wrong with my sata hdd? there are 3 plug jacks on it, 1 for info, 1 for power, and then 1 4-pin one that i dont know what it is for. is this the problem? please help!

(Pentium 4, 512mb RAM, 80GB seagate barracuda 7200 sata hdd, asus psgd1 mobo, lg cd-rw drive, 24-pin 350w atx psu. antec casing)

15 replies

by .martin.

in the heatsink on the CPU securely on? fan spinning?

by zack247

overheating because the fan is spinning and there is also a case fan with a vent tube attached too.

by oh smeg

Between the CPU and the Heat Sink the CPU will overheat extremely quickly and it will not make any difference if the Heat Sink fan is spinning or not.

It takes about .75 of a second to overheat a CPU when there is no positive contact between the CPU and it's Heat Sink.

Actually you could have Liquid Nitrogen pouring onto the Heatsink and that would make very little difference to the CPU overheating.

Col

by .martin.

having a visual check of the motherboard, check for any bulging or leaking capacitors.

by tintoman

for power supply
Earlier models had a molex power connector as well as sata becuase power supplies didn't always have the sata power lead fitted
You could try the other power connection to see if your system will boot.
However it seems to me that this is likely to be something elase like overheating cpu or bad memory modules

by timwireless

try checking if the motherboard is grounded which could cause the pc to prevent short circuiting or the BIOS could'nt quite recognize
your drive

by zack247

isnt a molex. it is much smaller. it doesnt say what it is anywhere on the hdd

by oh smeg

It is for connecting LEDs and the like to to give an indication when that drive is in use.

This connection [b]Is Not Used[/b] by most of the systems. ;)

Col

by oh smeg

There is something wrong with the M'Board which is causing the unit to fail. The give away is this bit off your description here

[i]if i unplug the power to the sata hdd, the computer will boot, but then it will shut off because there is no hard drive[/i]

This isn't right. The system should hang at a stage asking you to install a Boot Drive and stay there not shut down. I would remove the M'Board from the case and test on some clean white paper if it continues to do the same thing there is a issue with the M'Board but if it works correctly out of the case it is incorrectly mounted in the case.

Some M'Boards have a Supplementary 12 V DC Connector and if this isn't connected they will not function. This is either a 4-6 or 8 pin plug in addition to the 20/24 Pin ATX Connector.

Also ASUS P4 M'Boards do not have a Product Designation of [i]PSGD1[/i] they have a Designation like P4S800MX-SE with the P4X being the beginning of the M'Board model. ;)

Col

by zack247

it out of the case. but your theory of it being damaged wouldn't be far off. someone got it for me from their workplace, and they were told that the psu went in it. this could have either damaged the board or the sata. im not sure. but the sata didn't work with other mobos either...

by oh smeg

And make sure that the SATA was enabled and not in RAID Mode?

By default a lot of P4 ASUS Boards came with the SATA Ability either disabled or set to RAID.

Col

by zack247

that explains the 2 unconnected leds in the case. thx for the info!

by zack247

the motherboard isnt brand new, so im pretty sure the workplace i got it from had it set to sata and not raid

This discussion is closed to new replies.