Discussion Locked

Avance Logic ALS100 sound card driver

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello all, I need some help in putting an ALS100 (FCC id: MA5ASOUND) sound card to work on Windows NT 4 Workstation with SP6. I already have downloaded the drivers from various sources including the vendor, but I was not able to set it up until now.

The matter is that I religiously followed the instructions in the README file but it doesn't work. After choosing the correct driver in the "Control Panel | Multimedia | Devices | Add | Unlisted | ... " dialog box I receive another one stating that the driver already exists, I then choose the re-install.

Then, a dialog box for selecting the base I/O appears with 220 by default - I accept. After this I get another one to select IRQ, DMA and other parameters. I accept the defaults and receive an "Insufficient Memory" message, btw the PC has 128 MB.

After rebooting several times, I repeat all the procedure selecting some other options and sometimes I receive errors stating that the card was not found at a given IRQ, or the IRQ is already in use or, again, the is not enough memory.

I am really shocked. Has anyone a solution for this puzzle?

4 replies

by jdfcomputer

In order to narrow down the problem I would need to know what other hardware are installed on the computer and what type of computer it is.

Thanks

by ddiall

Please, check my post above (appended to the question). If you need further information or a *solution* post another answer. Thank you!

by ddiall

It is computer with a Pentium II 400 MHz processor, 128 MB RAM, a 1.6 GB hard disk, a standard CD-ROM, a simple 10/100 Ethernet NIC, an ATi Rage IIc video card and not much else.

In terms of software It has Windows NT 4 Workstation with SP6, Office 2000 and, again, not much else...

This discussion is closed to new replies.