Question Locked

Backup Exec 10.0d Job verify takes too long!

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a question about Backup Exec 10.0d. For the last couple of days the verify job has been running way too long. I'm not sure what the problem is. I have cleaned the drive but still have the same problem. There is nothing wrong with the tapes because it takes long on every tape. Anyone have any ideas, suggestions???

5 replies

by hal 9000

The head may be dirty and not reading the tape properly. You need to have a close look at the head to make sure that there is nothing on it as even one tiny spot will cause this to happen.

It's also possible that the Heads are worn out though not overly likely but I did see an Open Reel Video Tape Player constantly destroy it's heads because the room that it was in which was specially made for this unit had Fibreglass Insulation covered by Peg Board and there where bits of Fibreglass falling out every night when the TV Station was off air. This took ages to work out and after replacing the heads several times I eventually got there before they opened and found the fine covering of material over the unit. We cured the problem by just covering the Peg Board with solid Masonite and there was never a problem again.

The other thing that could have happened is that the Read Head is out of Alignment and the recording head is recording normally but the read head is not reading properly and takes much longer to read the contents of the tape and this could be causing the problem.

There is also the possibility that every tape is worn out as well so if the tapes are old try replacing a couple of them and see what happens.

If you have a test tape you can check out the drive and align the heads correctly.

Without knowing the make & model of the Tape Drive it's a bit hard to give a better answer.

Col

by eschlangen

I have been experiencing the same issues after updating my software to 10.0d. I'm using a LTO3 Ultrium single tape drive. The backup itself takes the normal time but the time for the verify has at least tripled and sometimes more. I have tried using a brand new tape and multiple head cleanings with no improvement. I find it difficult to believe that it is an alignment problem as the drive unit has not been moved at all since its installation. Any ideas would be greatly appreciated.

by ldorado75

The tape drive is a LTO1 Ultrium drive. This morning when I came in I checked the backup and everything looked normal again. I don't get it. I cleaned the drive last week a few times. Made sure there was nothing wrong with the tapes and checked the configuration on the jobs to make sure nothing was changed. I don't know what happend, but now it seems to be ok. I will know for sure when I come in tomorrow.

by joanne lowery

You could have severely fragmented hard drive / array. The backup is usually somewhat slower as the tape drive performs the write slower than the verify. Try a defrag of your partitions and see if this helps.
Also Veritas may be sitting waiting for an Alert response? If you go to the Alerts tab, have way down on the left you can configure automated responses to Alert situations (such as "remove media"). You can set the alert messages to expire or presume a positive response within a cetain time period. Most of my responses are set to 5 minutes.
Lastly, do you have anything else running on the SCSI bus that might be generating a large volume of traffic. Are you running a scheduled antivirus sweep, or defragging a database at the same time as the verify?

This discussion is closed to new replies.