Discussion Locked

Benefits of IP Printing question?

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
In my company we do not have a Print and File server, everything is located on the same server. All of our printers are connected to HP jet directs and named on the server. Is it beneficial to keep it that way or configure all of our pc's to print directly to an IP address on the jet direct. Will we save resources? Need benefits of both please

10 replies

by stillatit

The way it is now, if the server goes down, the users probably cannot print since they do not have the JetDirect drivers. If your server is fairly hefty and protected, this is probably not a problem, since a) the server won't go down often, and b) when it does they won't have files to print either.

If you have a reasonable server you are probably not loading it down at all with file and print unless you have a huge shop. (You can use performance monitor to see what the load actually is.)Adding the JetDirect drivers to each PC means that the users CAN print directly to the printers (but can still go through the server). This takes space on each machine, but disk is fairly cheap now.

I would recommend puting the drivers on the PCsof users who might need to print even if the server were dead, but leave their normal printing pointed at the server. Doing this gives them backup, but keeps the advantages of having centralized queueing (and print control).

Good luck.

by dcassat

I agree with message one. I will only add that in those configurations where I have a BDC, I duplicate the printers there also. If a server goes down, all of the TCP/IP address for the printers are on both servers and you can easily switch betweenthe queues on both.

by art23

To add to the scenario a little. Our server is a BDC and in the process of converting over to Ethernet for our entire location (a huge location)which will mean replacing all of the token ring Jet Directs. Our server was built by specs from our Corporate office which places a quota on everything and if that quota is reached(which it does once in a while) all printing stops. So with this addition, is it still better to keep the same print spooler on the server or go with direct printing with Jet Directs?

by wlbowers

I have JetDirect installed on every machine in my network. They access the printers direct through HP JetDirect 500x print servers. No server intervention. This removes the load from my server and works just fine. I did this because I was having problems routing through the server. My printing is mixed with JetDirect and EpsonNet.

Hope this helps.
Good Luck Lee

by mishratron

i will not answere this question untill someone beefs up my 10 megabit fiddiethernet token ring

This discussion is closed to new replies.