Question Locked

BIOS HDD detection

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I'm trying to install,partition & format a new HDD for a IBM R31, with no luck. I'm usually very handy at this computer stuff, but I'm really stuck. The drive isn't being reconized in the BIOS, though when I boot-up with Win98 boot disk the drive is reconized. I ran bootmaster and it also reconized the drive, but it it also gave me this error message," The bios HDD detection may not be correctly translating the CHS parameters for drive 1". I do wish to mention that before I got into this mess, I had up-dated the BIOS for this machine.
Any help with this would be most appreciated, as I have being working on this for 2-3 weeks now, and my husband is about ready to leave me.(not sure if that would be a bad thing). Also, it's cutting into my fishing time. TY

6 replies

by thechas

It sounds like the drive is larger than the BIOS can recognize.

Just because you installed a BIOS update does not mean that the BIOS can recognize the latest hard drives.

Since you mention Windows 98, keep in mind that the version of FDisk that is on the Windows 98 startup disk is limited to around 64 GB. Microsoft does have an update you can download that extends FDisk to 136 GB.

What you may need to do, is boot up using the drive manufactures utility disk and install their BIOS overlay software. This software tricks the BIOS into working with a drive larger than the BIOS can recognize.

Let us know what size drive, and what file system / OS you plan to install on it if you need more help.

Chas

by mcjd2

Ok,
I'll go the HITACHI site and get their disk utility. Thanks alot.

by mcjd2

Hi again,
I did what you said and got the manufactures utility disk and changed my HD capacity to 20 gigs, which it is. I then run my Win 98SE boot disk , hit F1 to open the BIOS , and the drive was listed correctly. I then partitoned it with the Win98SE disk, which supports HD's over 500 MB. I then put in my Win XP home boot disk and it reconized the drive as 674 gigs instead of the 20 gigs, and it wouldn't let do anything to it. So, I re-booted again, checked the BIOS, and guess what? No HD listed. I put the manufactures HD utility disk back in , tried to change the HD capacity again, and it confirmed the change. I then checked out the BIOS, no HD listed. So, what do you think? Do I need to replace the system battery? I appreciate all the help. JC

by thechas

When you use the drive manufactures utility to set up a hard drive, you usually have to follow a specific sequence in order to boot from a floppy or CD and use the drive.

Check the manual for the drive utility. It should provide instructions for how to boot from a floppy or CD after installing the utility.

If you are going to install XP, the only reason to use a W98 startup disk is if you want a FAT 32 format on your drive. Otherwise, you should be able to follow the drive utility instructions for booting from other media.

Usually, the first sign of a weak CMOS battery is that the real time clock starts to loose time. However, if the system is over 5 years old, it would not hurt to change the battery now while you are working on it.

Chas

by mjd420nova

Pull the battery for the CMOS and replace it with a new one. How did you update the BIOS?? Did you flash it online?? If you can, check the BIOS for the hard drive automatic drive detection too.

This discussion is closed to new replies.