Question Locked

BIOS will not change HD priority

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I installed a new 160GB serial HD. Wanted to use my old 40GB as extra storage. Deleted partitions, formatted and installed a partition so I could use the total volume. Booted my machine and I get a BOOT DISK ERROR. I check the BIOS. It has my old HD in 1st priority. I change to the new HD, save and exit. On rebooting I get the same error message. I unhook the old HD and reboot. The system starts fine. I turn the machine off, reconnect the old drive and reboot. Everything comes up OK. I reboot again and I get the error message. For some reason I get one good boot with the old HD connected before I get the error message again. I check the BIOS when I get this and it shows the old HDin 1st priority. I don't understand what's going on. Does anyone?

3 replies

by hal 9000

On just about every M'Board the IDE Drive are the default drives to boot from and the SATA Drives if not actually needing drivers do write some files to the Default Drive to tell the computer where to find the Boot Drive or the boot files as well as any SATA drivers that where required to be installed.

What it sounds like you have done here is to install the OS onto the SATA HDD without the IDE drive being present or partitioned so it becomes blank to the system. When you partitioned the IDE Drive that became the Default Boot Drive and the system is looking at that for the directions on where to find the OS to boot from. As there are no files there you are getting the error massage and it doesn't matter how the Drive Names are setup within Windows at the BIOS Level the IDE drive will always be the C Drive.

The solution is to perform a In place Install of your OS with the IDE Drive in Place and select the SATA drive to install the OS to buy [b]Do Not!!!!![/b] disconnect the IDE Drive as the necessary files never will be written to the default drive to point the computer where to look for the Boot files to allow the system to load.

You can perform a In Place Install or Repair Install by following the directions here

http://tinyurl.com/g4bv8

Col

This discussion is closed to new replies.