Discussion Locked

Blinking cursor after NT 4.0 reboots

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Within the last two weeks I've had three different pc's fail after they reboot. They have the latest virus software running. I can plug the drive as a slave drive and I can access the disk with no problem, but I just can not boot from the drive. I've tried fdisk /mbr; nothing. I've checked the partition table and also ran NT repair and nothing. Any ideas?

4 replies

by ksimmons

How far along does it get to the reboot? Can you select the last known good configuration? Have you checked the connections to the drives? Are you running IDE or SCSI? Is this an Alpha or a Intel configuration? Were you running a mirrored set?Under what conditions were they rebooted? Was it a controlled shutdown or a power outage? Please advise.

by jeannethe

The computers were shut down correctly, they all have IDE drives and they only get passed POST. NTLoader is not initiated. I tried repairing as well as copying NT system files (Ntdlr, boot.ini)from other systems; nothing. I also tried using the same drives on a different system, same results.

This discussion is closed to new replies.