Discussion Locked

boot disk for multiple domains

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
how can i create a multiple domain boot disk for my laptop computer? uses zircom 10/100 pcmcia ethernet card.

5 replies

by it-sage (bschirf)

Since your question wasn't about creating a boot disk for one domain, I will assume you can create a single-domain bootdisk. If not, post another question for that.

Just as you can only log onto one domain at a time via NT, the same goes for DOS. (ie: Bootdisk) You can log onto one domain and then map a drive to another as long as there is a trust between the domains.

First, go to the Zircom website and get the drivers for a Netbios DOS bootdisk. Once you have a diskette that boots up with the Netbios network drivers do the following in the Config.sys
-------------

[MENU]
MENUITEM=DOMAIN1, Boot into domain #1
MENUITEM=DOMAIN2, Boot into domain #2
[COMMON]
device=a:\dos\himem.sys /testmem:off
devicehigh=a:\net\ifshlp.sys
files=50
buffers=40
DOS=HIGH,UMB
stacks=9,256
lastdrive=z
[DOMAIN1]
[DOMAIN2]
----------------
This will provide a menu upon bootup and passes the option selected into the Autoexec as %config%.

In the Autoexec.bat
---------------
@echo off
LH a:\dos\smartdrv.exe /x
LH a:\dos\doskey
set dircmd=/o/p
prompt $p$g
path=A:\;A:\DOS;A:\NET
ECHO Logging onto %config%
net logon /domain:%config% /savepw:no /yes
net use x: \\server\share /savepw:no
:END
---------------
This will echo the domain you selected, and then prompt you for your userID and password. Next, it maps you to some specific share on that domain.

HTH...

This discussion is closed to new replies.