Discussion Locked

boot error

0 helpful

11 replies

by masterp Jul 10, 2001 last reply Jul 13, 2001

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a PC with a new hard drive. When I boot it with a win 98 startup disk I get the error "BSP CPU......Err:Microcode"
Any Ideas?

11 replies

Guess is that this a a haard drive error message that is caused by low level formatting from the manufacturer,contact the vendor of your hard drive

Poster rated this answer

If your disk is ok, you must probe make again the boot diskette, may be is corrupt. I had sometime, similar error. Try it.
Hope it helps you.

Poster rated this answer

Sounds like hard drive is damaged. Is the hard drive making any noise?

You should try installing the hard drive as a slave drive to see if its the hard drive or any of the hardware on the machine?

Yikes. Good luck.

Poster rated this answer

change your win98 startup disk with a newly formatted floppy disk.

Poster rated this answer

This question was closed by the author

Still get the error but it runs great. Guess I will see what happens down the road. Thanks for your help.

Still get the error but it runs great. Guess I will see what happens down the road. Thanks for your help.

This discussion is closed to new replies.