Discussion Locked

Boot problem

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When I switch on my computer this morning, I got this message and couldn't boot up Windows(95):
SDRAM at Bank # :2
Searching for boot record from floppy..not found
Searching for boot record from IDE-0..ok

Invalid system disk
Replace the disk,and then press any key.

Have no problem booting from Win95 boot disk.
But couldn't boot up Windows.

Please help!

Thank you.

9 replies

by taiseermustafa

Did you open any MSG yesterday contaning one of the below attachments?
"An Internet Flower For You" or "A Virtual Card for You"?
When you boot from your boot disk can you access the HD, I mean C: drive?
Do you have any Bootable Virus Scan disk, to check if your Master Boot record infected or not?
Please advise so we can help you further.

Good Luck

by michelinda

You may have had a bios battery go bad. Sometimes when the battery goes, it "forgets" the hard drive and can't go further. If you have the choice booting up, to F2 or "delete" to enter setup, try going into setup. Look for something that says "automatically detect harddrive". Let the bios find it, save it and go out. If you haven't turned it off, it will retain the setting and let you go into Windows. IF the battery is the fault, and you turn it off, you will have to detect the hard driveeach time untill you replace the battery.

by michelinda

You may have had a bios battery go bad. Sometimes when the battery goes, it "forgets" the hard drive and can't go further. If you have the choice booting up, to F2 or "delete" to enter setup, try going into setup. Look for something that says "automatically detect harddrive". Let the bios find it, save it and go out. If you haven't turned it off, it will retain the setting and let you go into Windows. IF the battery is the fault, and you turn it off, you will have to detect the hard driveeach time untill you replace the battery.

by bean baggins

The most likely problems are: your hard drive is failing; your boot files (io.sys etc) are damaged or missing; you have a virus, your drive was using a drive overlay that is now damaged. Before doing anything else, get a bootable anti-virus disk with the latest virus definitions, then boot from it and scan your hard drive. If you get an I/O error reading the HDD, your drive is failing. If you get an error 'invalid drive specification' you're HDD has probably been set up with an overlay (ie. OnStream, Maxtor EZ-max) or your drive is failing. If the virus scan completes with no viruses found then boot using your Windows boot floppy. At the A: prompt type 'sys c:'. This will copy the system files from your floppy to the HDD. Make sure the boot disk is the from same version of Windows. Try rebooting. If you can boot from the HDD, great, if not, obtain a drive diagnostic disk (usually downloadable from the drive manufacturers web site) and run a thorough diagnostic. Good luck.

This discussion is closed to new replies.