Discussion Locked

Brand spanking new computer and no power

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have just put together a new computer with a
iwell moptherboard, AMD processor, new video card, hard drive from old computer, modem from old computer, nic card for cable modem from old
computer, new RAM, new case and power supply.

I plug it in and the fan on the AMD processor and the power supply run for about 2 seconds
and then nothing. I have tried pulling each card seperately and then turning it on and still nothing. I finally reseated the RAM and
it started up, but it was not hooked to monitor or anything else. So when I sat it back down on the floor I decided to try the
power one more time, and NO POWER!!

What gives, any ideas?

Mark

11 replies

by some guy in seattle

sounds like a bad power supply, which could be a result of two things. An actual bad power supply or too much equipment exceeding the current limitations of the power supply (too much load). I doubt it's the second if it's a newer power supply since most manufacturer's know that contemporary PCs have lots of peripherals. I doubt it's any of the PC boards or peripherals. Try removing peripherals to see if it will boot with just the motherboard, keyboard, mouse, and monitor. If so, then there may be the load factor. If not then I'd say it's bad power supply causing intermittent failures.

Hope that helps -

by sritter

It could be the fan on the cpu. Many new motherboards monitor the fan speed of the cpu fan. If it is not running, the system will not continue booting. The next most likely thing is the power supply is bad.

by mbr2

I took the power supply from my old computer and just plugged it in to the mother board and it didn't work. I did not hook the power up to any of the components, i.e. hard drive, floppy, etc. I just placed my old case next to the new one and plugged directly into the motherboard and switched on my old computer. Should I completely take out the old power supply and fully install the one from my old computer?

by @lberto

hmmmm,
Remove all the cards, just leave the mainboard with Memory and processor, try to turn it on, check if the power cable that comes from the power Supply to the mainboard is properly attached, check if the processor is properly inserted on its sock.
If none of this works then get a power supply because your's is not ok.
If still it doesn't work e-mail me back and we will walt thru it.

Good luck,
@lberto
alberto@pancarib.com

by bohicam1

Go through your motherboard manual, near the beginning of the manual where it talks about all the jumper settings. Check to make sure the jumper for the keyboard is set correctly to power on with keyboard even though the keyboard has no power button. There are three pins on there, usually the first one is numbered. You must have the jumper on 2 and 3. If this is the case, try putting the jumper on 1 and 2.
Good luck!

Mike

by mphoffar

I'd probobly yank the board, find a good piece of foam or something to insulate it and apply power there. It sounds like you're grounding on the case somewhere.

Mark

This discussion is closed to new replies.