Discussion Locked

Browsing

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have install member servers win2k, in a win nt4 domain (dhcp & printer servers). Some I can browse & others I can not. Why is this so? Please help.

5 replies

by johnscrooby

John...

this may sound obvious, but- are you running an internal DNS server on your network? I started my win2k install as a mixed domain asell and couldnt see any of my NT boxes..i was running wins but that didnt seem to help. I installed a dnsserver and manualy made hosts for all the NT machines - that sorted me out. Also when you intalled your 1st DC on for Win2k, theres a section where you can specify that you want pre-win2000 privlages on the domain - You should have selected that option.. hope this helps.

by izz

Well, according to ur limited info. I can spot the following issues that u have to check. First do u support WINS on ur already existing NT4.0 domain, I think that u should, cause it is good to reduce broadcast. Well, in DHCP did u specify the WINS node type and WINS server IP adddress (044, 046). If u did that probably, then go to W2k Server and try the ipconfig/all, if WINS IP address is there, then u shouldn't have problem finding other clients or servers on the network. I am sure that if the W2k server is not deifned with the WINS IP address it will cause u this trouble.

Hope this helps

This discussion is closed to new replies.