Discussion Locked

Browsing from another subnet?

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 2 subnets on one physical wire...192.168.190.0 and 192.168.181.0. We have grown in size in that we are now overflowing from our 190 net and using 181 addresses. The 9x users on the 181 network cannot see the rest of the network (which is mostly on the 190 network). I have file & print sharing turned on. Is there something else that I am missing?

9 replies

by johnd

Have you got the right subnet mask set? You say you have all machines on one 'Physical wire' Are you switched (VLANs) or routed (access lists, gateway)

by rogerndgreen

Your IP addys are 192.168.190.xxx & 192.168.181.xxx
Assuming you have a subnet mask of 255.255.255.0, you will have no way of getting these two subnets to talk to each other, unless you put a router in the LAN somewhere.
This will need to have an routing table setup between the two subnets, and every workstation will need the appropriate gateway address configured.

For example, suppose you had a router set up on 192.168.190.1 & 192.168.181.1
Then you need all your "191" workstations to have a default gateway address of 192.168.190.1 (and all your "181" workstations to point to the 192.168.181.1 gateway.
It's immaterial in this instance that all the nodes are on the same physical wire.

HTH

Roger

by timber

I agree with the last answer an easy way to solve this is to use NT as your router with two nics. This is a little cheaper than buying a full blown router since a lot of the features won't be used for what you want.

by joshg

If all of your PC's are on the same LAN and are not concerned with 190 users getting to the 181 network and vice versa, just change your subnet mask on the servers and your DHCP server to something like 255.255.0.0, you will be able to see all the nets from 192.168.1.0 to 192.168.254.0 in your net neighborhood.

This discussion is closed to new replies.