Discussion Locked

Browsing Problems due to NetBIOS conflic

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Workstations in LAN-A are unable to access shared folders on the LAN-B's PDC. I checked the permissions on B and see that I am unable to set any permissions for A's groups, the old one's no good. I tried removing (worked), but then couldn't add. On LAN-A's PDC I've got a message indicating a NetBIOS conflict, that runs back to the LAN-B PDC. Could this be the root of the problem? How do I resolve the conflict (have been spending mucho time at MS site with little to show)?

Thanks,
Jeff Gringer
jgringer@marcocorp.com

5 replies

by sarsone

You need to set up trust relationships between the domains.

In the usermanger for each domain, add trusting and trusted domains to the trust and trusted lists.

The online help for Trusts are great and should guide you through it.

Dan

by jgringer

There is a trust relationship already established. It is on-and-off. The shared folder in question had worked between the two LANs, then decided it wanted to quit working.

by gicu artistu'

Are the two lan's on different subnetworks? If they are something needs to do the routing between them. NT supports dynamic routing on multihomed computers. If you already did this then check in your network config if you have the NetBIOS inteface installed. If you have it then check the NetBIOS routes (select it and click Proprties). If everything is right then check your trust relationships.

Luck

by jgringer

The two LANs are indeed different subnets, connected through a CISCO 2600 and Lucent APs. The trust relationship was establish, and these shared folders had worked before, then went sideways on me. I'll look into the NetBIOS interface.

Thanks

This discussion is closed to new replies.